-
Notifications
You must be signed in to change notification settings - Fork 131
BasicMechanicalSkills
ligi edited this page Oct 26, 2024
·
6 revisions
In survival situations, having basic mechanical skills can make the difference between safety and danger. This section covers essential mechanical tasks and repair techniques for vehicles, aircraft, and boats.
- Cleaning: Regularly clean tools after use.
- Sharpening: Sharpen blades using a consistent angle (around 20 degrees).
- Hammer Substitute: A rock can serve as a makeshift hammer.
- Lever Substitute: A sturdy stick can be used as a lever.
- Battery Check: Ensure connections are tight and free of corrosion.
- Fuel Supply: Listen for the fuel pump when the key is in the "on" position. If silent, the pump may need attention.
- Spark Plugs: Inspect for wear or carbon buildup. Clean or replace as necessary.
- Loosen Lug Nuts: Use a lug wrench.
- Jack Up Vehicle: Use the jack at the designated point.
- Replace Tire: Remove the flat tire, replace it with the spare, and tighten the lug nuts in a crisscross pattern.
- Patch Kit: Use a rasp tool to roughen the puncture area and insert a plug.
- Tire Sealant: Inject sealant through the valve stem and reinflate the tire.
- Cool Down: Wait for the engine to cool before opening the radiator cap.
- Hose Inspection: Look for leaks or cracks and apply temporary fixes with tape if necessary.
- Inspect Pads: Listen for squealing or grinding.
- Replace Pads: Remove the old pads and install new ones.
- Check Levels: Top off if braking feels spongy. Bleed the brakes if necessary.
- Fuel Line Check: Inspect for blockages and clear them if found.
- Fuel Filter: Clean or replace if clogged.
- Inspect and Clean: Check for carbon deposits and clean or replace as needed.
- Battery Check: Ensure the battery is charged and connections are tight.
- Wiring Inspection: Look for loose or corroded connections.
- Test Functionality: Check the alternator belt and replace if faulty.
- Ailerons, Rudder, Elevators: Inspect for damage. Replace frayed or broken control cables if possible.
- Hinges and Bolts: Tighten loose bolts and replace damaged hinges.
- Temporary Patch: Use duct tape, canvas, or clothing to plug holes.
- Epoxy Repair: Clean the area and apply marine epoxy over the breach.
- Check Bilge: Inspect the bilge area for water accumulation and trace it back to its source.
- Fuel Line and Filter Check: Inspect and clear blockages. Use a water separator if water is in the fuel tank.
- Cooling System: Clear blockages in the intake or outflow. Replace the impeller if damaged.
- Inspect for Damage: Secure the rudder temporarily with strong rope or wire.
- Cable Tension: Replace or tighten steering cables as needed.
- Check for Debris: Remove any tangled debris.
- Replace Propeller: Use a propeller puller to replace a broken blade.
- Battery Maintenance: Ensure the battery is secure and connections are corrosion-free.
- Bilge Pump: Check wiring and replace or repair the pump if necessary.