Tanix Tx3 ; Aml multiboot not applying

[danidanibaerboo]

Hey everyone, I've been experimenting with Debian on a USB and everything has been working great. Both the Wi-Fi and Ethernet are functioning properly.

The issue I'm facing is that running ./aml-multiboot.sh script, it doesn't return any errors. However, my TX3 won't boot from the USB automatically. I still have to hold down the reset button for it to boot from the USB.

Unfortunately, I only realized this after running ./install-to-emmc.sh , which resulted in a bootloop.

No other image/armbian/llinux has been flashed before.
Slimbox firmware installed prior to attempt.
Screenshots were from second attempts (after bootloop as I thought I did something wrong).

[devmfc]

can you try:
replace /root/aml-multiboot-setup.sh with attached version and then run:

fw_setenv cmd_boot_org
./aml-multiboot-setup.sh
fw_printenv

and post the output here?
aml-multiboot-setup.zip

My images are created for stock vendor bootloaders. I don't know what version bootloader SlimBox uses. But if it doesn't work, you will have to go back to stock firmware before installing multiboot.

[danidanibaerboo]

I discovered that I have a fake uboot,

which bricked my device when I tried to multiboot and install it to the emmc (weird as it didn't throw any error).
Tried AML burn tool, it got stuck at 7% with a uboot error (QZ and BZ firmware).

Ended up returning the device and got a new one . Retried all previous step and got it working perfectly.

Thanks for your work!