xdrip-js

Please note this project is neither created nor backed by Dexcom, Inc. This software is not intended for use in therapy.

Installation

git clone https://github.com/thebookins/xdrip-js.git
cd xdrip-js
sudo npm install

Testing

npm test

Example usage

sudo node example <######> where <######> is the 6-character serial number of the transmitter.

To see verbose output, use sudo DEBUG=* node example <######>, or replace the * with a comma separated list of the modules you would like to debug. E.g. sudo DEBUG=smp,transmitter,bluetooth-manager node example <######>.

bluetoothctl is used to accept the incoming pairing request. From a command prompt, enter bluetoothctl and then enter the following commands (some may not be necessary depending on your configuration):

• agent off
• agent KeyboardDisplay
• default-agent
• pairable on
• power on

When the transmitter is found, type 'yes' to accept the pairing request:

To view the current status of the transmitter, open a browser and navigate to http://<local IP address>:3000. E.g. http://localhost:3000 or http://192.168.1.3:3000. This will vary depending on your local network setup.