USB: xhci - fix bit definitions for IMAN register

According to XHCI specification (5.5.2.1) the IP is bit 0 and IE is bit 1
of IMAN register. Previously their definitions were reversed.

Even though there are no ill effects being observed from the swapped
definitions (because IMAN_IP is RW1C and in legacy PCI case we come in
with it already set to 1 so it was clearing itself even though we were
setting IMAN_IE instead of IMAN_IP), we should still correct the values.

This patch should be backported to kernels as old as 2.6.36, that
contain the commit 4e833c0 "xhci: don't
re-enable IE constantly".

Signed-off-by: Dmitry Torokhov <[email protected]>
Signed-off-by: Sarah Sharp <[email protected]>
Cc: [email protected]

drivers/usb/host/xhci.h

@@ -206,8 +206,8 @@ struct xhci_op_regs {
 /* bits 12:31 are reserved (and should be preserved on writes). */
 
 /* IMAN - Interrupt Management Register */
-#define IMAN_IP		(1 << 1)
-#define IMAN_IE		(1 << 0)
+#define IMAN_IE		(1 << 1)
+#define IMAN_IP		(1 << 0)
 
 /* USBSTS - USB status - status bitmasks */
 /* HC not running - set to 1 when run/stop bit is cleared. */