Z offset not working

[WatWall]

Today I've installed klipper mod again. Didn't change any setting, Set bed temp to 60, extruder to 120 and did a bed mesh calibration through guppyscreen and saved the profile at the end.
Then I did a test print but z offset was way too high.
Also force leveling before the print does not make any difference.

[WatWall]

I calculate Z offset as 0.25 (not -0.25) and save it but no change at all in z offset while printing

[santahx]

Hey hier von PRINT_START
welches immer am anfang deines Gcodes ausgeführt wird

Musst bei den macros.cfg in macros.cfg einfach mit strg + f PRINT_START suchen und voila. Da musst du deinen wert anpassen.
Mit Freundlichen Grüßen Nicolas Bissinger

SET_GCODE_OFFSET Z=0.0  ; reset the G-Code Z offset (adjust Z offset if needed)