You must boot into bootloader to flash the firmware，you have some choices to do it
- for stock firmware，click “Reboot to Bootloader” if your keyboard listed in the device list
- Pulled down the BOOT pin
- If you have a jumploader ，It’s strongly recommended to flash the jumploader on SN32F260 since the 260 series can become brick if the bootloader is overrided. See
- Set qmk_offset to 0x200 only if you have a jumploader flashed in the keyboard
python3 -m venv venv
. venv/bin/activate
pip install wheel
pip install -r requirements.txt
fbs run
# or "fbs freeze" to create the package
Alternatively, if you're running NixOS or have Nix installed, you can run
nix shell
fbs run
To run it for immediate use, just run run.sh and it'll set itself up and run.
Run with sudo to flash unless you have the correct udev rules set up.