Fome is a new project intending to deliver a user focused high feature ECU with open source hardware options and open firmware that give control back to the user, owner and driver.
As there are many complicated topics to cover we recommend that you start with the topics in the "intro" section to the left. The first page to view should probably be the ECU-tech Overview page.
- ECU-tech Overview
- Which ECU-tech hardware to choose
- Where to get firmware
- Updating the firmware
- Performing a safe first start
- How to setup a board for first use
- How to test inputs and outputs
- Tips and Tricks
- How to pick the right fueling method
- Guide to ETB and VVT PIDs
- Miata MX5 Quick Start Guide
- Air Fuel Ratio
- Acceleration Compensation
- What is Charge temperature estimation
- What is knock and why it matters
- Multi-dimensional mapping, what is it and how to benefit from it
- Spark timing, MBT and combustion
- Accelerator pedal
- Battery Settings
- Brake pedal position and pressure sensor
- CAN gauge
- Clutch Pedal position and pressure sensing
- Rev Counter
- WBO2 Wideband Lambda
- Analogue input settings
- Aux sensors
- Cam sensor
- Crank sensor
- ETB TPS
- Mass Air Flow Sensor
- TPS
- Turbo Speed Sensor
- VSS
- Boost Pressure Limit
- Coolant based RPM limit
- Fuel Pressure Compensation
- Minimum Oil Pressure Protection
- Rev limiters
- Bench test commands
- Boost control
- Cylinder Bank Selection
- Data Logging Settings
- Fan Control
- Fuel pump relay control
- GPPWM General purpose PWM
- Main Relay control
- Advanced Idle control
- Closed loop idle control
- Idle hardware
- Idle ignition table
- Idle settings
- Idle VE Table
- Idle tuning
- CAN settings
- Cylinder Angle Offset
- Knock control
- Launch Control
- LUA Scripting
- MAP sampling angle
- Multi-Dimensional Mapping
- Override Table Axis
- Smart Alternator
- ETB bias table
- ETB idle control
- ETB pedal target
- ETB PID and auto tune
- ETB Settings
- Redundant sensors
- Barometric pressure compensation
- Charge Temperature estimation
- Closed loop fueling
- Injection Phase settings
- Injector tester
- AFR settings
- Coolant Multiplier
- Per-Cylinder Fuel trim
- Deceleration Fuel Cut Off
- Flex Fuel
- Fuel Injection Mode
- TPS Multiplier
- Intake Air Temperature Multiplier
- Injector Deadtime settings
- Small Pulse width correction
- High/Low circuits
- Highside circuits
- Lowside circuits
- Power supply circuits
- Discrete VR
- PT2001
- STM32 Compatibility
- Base boards
- Brain boards
- CAN Gauge
- Low-Z Driver board
- Power Steering Controller
- Wideband Lambda module